详细说明

Dog TPA ELISA Kit 96T

价格：1800
收藏
产品编号 NG-EN419
  • 产品简介
  • 产品细节
  • 操作步骤

This Dog TPA ELISA kit is intended Laboratory for Research use only and is not for use in diagnostic or therapeutic procedures. The Stop Solution changes the color from blue to yellow and the intensity of the color is measured at 450 nm using a spectrophotometer. In order to measure the concentration of Dog TPA in the sample, this Dog TPA ELISA Kit includes a set of calibration standards. The calibration standards are assayed at the same time as the samples and allow the operator to produce a standard curve of Optical Density versus Dog TPA concentration. The concentration of Dog TPA in the samples is then determined by comparing the O.D. of the samples to the standard curve.


Dog TPA ELISA Kit 96T
Assay Type
 Solid Phase Sandwich ELISA
Format
 96-well strip plate/48-well strip plate
Assay Length
 2.5 hours
Sample Type undefined Volume
Required Per Well
 Cell Culture Supernates (10 uL), Serum (10uL),Tissue or cell lysate (10uL)
Sensitivity
 3.75 U/L
Assay Range
 3.75-120 U/L(Cell Culture Supernates, Serum,Tissue or cell lysate)
Specificity
 Natural and recombinant Dog TPA
Cross-reactivity
 <0.5% cross-reactivity observed with available related molecules.<0.5% cross-reactivity observed with available related molecules.
Interference
 No significant interference observed with available related molecules.
 
 

Qualitative Detection
1. Prepare all reagents before starting assay procedure. It is recommended that all Standards and Samples be added in duplicate to the Microelisa Stripplate.
2. Add standard: Set Standard wells,testing sample wells.Add standard 50μl to standard well.
3. Add Sample: Add testing sample 10μl Then add sample diluent 40μl to testing sample well; Blank well doesn’t add anyting.
4. Add 100μl of HRP-conjugate reagent to each well, cover with an adhesive strip and incubate for 60 minutes at 37°C.
5. Aspirate each well and wash, repeating the process four times for a total of five washes. Wash by filling each well with Wash Solution (400μl) using a squirt bottle, manifold dispenser or autowasher. Complete removal of liquid at each step is essential to good performance. After the last wash,remove any remaining Wash Solution by aspirating or decanting. Invert the plate and blot it against clean paper towels.
6. Add chromogen solution A 50μl and chromogen solution B 50μl to each well. Gently mix and incubate for 15 minutes at 37°C. Protect from light.
7. Add 50μl Stop Solution to each well. The color in the wells should change from blue to yellow. If the color in the wells is green or the color change does not appear uniform, gently tap the plate to ensure thorough mixing.
8. Read the Optical Density (O.D.) at 450 nm using a microtiter plate reader within 15 minutes.

相关产品

沪公网安备 31011402005773号
在线客服
  • 电话 点击这里给我发消息
  • 客服电话：
  • 400-801-0594
  • 在线客服
×